High Quality Water Softener Replacement Resin
WATER SOFTENER REPLACEMENT RESIN MEDIA
WORKS IN MOST WATER SOFTENERS INCLUDING RAIN SOFT, SEARS KENMORE, AND CULLIGAN TO NAME A FEW.
**Please Note: Resin that is shipped may not be the exact brand listed and shown in the picture listed. Depending on available stock brands may vary, but the quality of the Resin shipped is exactly the same regardless of the brand name. Our resin is high quality 8% crosslink chlorine resistant softening resin.
COMMON SYMPTOMS THAT IT IS TIME TO REPLACE YOUR WATER SOFTENER RESIN ARE:
Low water pressure: this is caused by the resin gelling up and leads to pressure loss.
Not functioning properly (i.e. not softening, no longer removing iron): This is caused by the beads “cracking: and losing their functionality. This is common on municipal water where the chlorine dries out the resin.
A MAJOR PART OF A WATER SOFTENER IS THE MEDIA INSIDE OF IT. IF YOUR SOFTENER IS WORKING MECHANICALLY, BUT NOT SOFTENING THE WATER, THEN REPLACE THE MEDIA INSIDE, INSTEAD OF THE WHOLE WATER SOFTENER.THE RESIN IS PACKED IN ONE CUBIC FOOT BAGS. PLEASE USE CHART BELOW TO DETERMINE HOW MUCH IS NEEDED FOR YOUR TANK:
8X44 TANK = 3/4 BAG
9X48 TANK = 1 BAG
10X54 TANK = 1.5 BAGS
12" OR 13" DIAMETER TANK = 2 BAGS
IF YOU HAVE ANY QUESTIONS REGARDING THE AMOUNT OF RESIN YOU NEED FOR YOUR TANK/ SYSTEM SIZE PLEASE EMAIL US. The process for replacing your resin is simple. Just open your Softener (not the salt tank) and Wet-Vac the old resin out, then pour the new resin in. Then backwash your system and you're good to go!